Coats 6450 3D Bedienungsanleitung PDF herunterladen (Seite 21)

Important: Always read and follow the information box instructions. • 15

Standard Front Cone Mounting

Can be used with all cones (do not use spring). This

method works well with most truck wheels where the

bolt circle is less than 275 mm.

1. Select a cone that best fits into wheel center hole.

2. Lift wheel onto threaded shaft.

3. Slide selected cone onto shaft with the small end

against the wheel.

4. By lifting wheel from bottom, center on cone.

5. Thread hubnut on and tighten with hubnut wrench.

If hubnut won’t tighten all the way down, remove cone

and wheel. Slide truck cone spacer over faceplate and

repeat steps 2 thru 5. The wheel must be forced firmly

against the faceplate.

6. If you still can’t tighten hubnut because of a lack

of threads, use an additional cone to act as a spacer

between the hubnut and existing cone.

Figure 18 - Front Cone Mounting

Combi Adapter (Optional)

1. Determine the correct hole pattern by comparing

the rim to the adapter. Wheels with the largest bolt cir-

cle (335 mm) should be fastened to the large diameter

side of the reversible adapter - all others should be fas-

tened to the small diameter side (see illustration below).

2. Fasten threaded studs from back of adapter

using the 5/16 Allen wrench. Leave enough threads to

securely fasten hex nuts and lock washers.

3. Slide lock washers on. Hold the studs in place with

the 5/16 Allen wrench while threading the hex nuts on,

then tighten them down with a 5/16 wrench.

4. Mount the adapter onto the faceplate by inserting

the two (2) drive pins of the adapter into the matching

holes in the faceplate.

5. Slide truck cone onto shaft with the small end

inside the center hole of the adapter. Mount by front

cone method only.

6. Thread hubnut on and tighten with hubnut wrench.

The adapter must be forced firmly against the faceplate.

7. Mount the wheel onto the adapter’s lugs. Fasten

wing nuts by hand then securely tighten them with a

rubber mallet. Wheel must be forced firmly against the

faceplate.

CAUTION

Wing nuts must engage threads for at least

six full turns. Hubnut and cone must force

wheel and adapter firmly against the face-

plate. Failure to tighten hubnut or wing-

nuts securely may result in serious personal

injury.

Figure 19 - Front Cone Mounting

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Coats 6450 3D Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Coats 6450 3D