Coats 6450 3D Bedienungsanleitung PDF herunterladen (Seite 11)

Important: Always read and follow the information box instructions. • 5

Figure 7C - T2-Tape (Hidden Tape-A-Weight®) Data Entry

Diagram

Using The Laser Locator

If the T2 - Tape (hidden Tape-A-Weight®) location is

selected, use the laser locator to point to the hidden

weight location (figures 8 & 7B). Rotate laser locator

knob to position the laser dot outboard at the desired

T2-Tape (hidden Tape-A-Weight®) location.

Note: For best performance, choose a weight position

outboard as far inward (in the rim) as wheel allows.

Figure 8 - Positioning Laser Dot At T2 - Tape Hidden Weight

Location (A2)

Note: The T2 - Tape Direct Select™ Weight position

is the only mode that requires the A2 & D2 dimension

measurements.

Using The Line Laser

If the T2 - Tape (hidden Tape-A-Weight®) location

is selected, use the line laser to align the offset arm

with the laser locator dot (figures 8 & 7B); entering

A2 & D2 measurements automatically. Grasp arm at

the line laser and pull out and up to the wheel flange

(figure 6B). Hold arm still at the clip-on weight location

and wait for BEEP. Then, before returning arm to home

position, press button on line laser to activate the line

laser beam. Move arm to inner area of wheel and align

line laser beam with laser locator dot (figure 8). Hold

arm still, up against the rim, in the same plane as the

T2-Tape (hidden Tape-A-Weight®) location (figure 7A &

7B) and wait for BEEP. Refer to figure 9.

Note: The line laser remains on for ten seconds after

its button is pushed.

Figure 9 - Positioning Line Laser Beam At T2 - Tape Hidden

Weight Location (A2)

3D - Using the Hood Sonar

When prompted by the balancer instructions, use the

hood sonar - width sensor (figure 10) to enter wheel

width measurement automatically. Lower balancer

hood guard to enter the measurement.

Figure 10 - Tire Width Sonar Located Inside Hood

Note: Refer to page 7 to measure the W dimension

manually using the plastic calipers (2D & 3D models).

Laser

Locator

Dot

Laser

Locator

Knob

Center Line

Laser Beam

on Laser

Locator Dot

Press Line

Laser Button

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Coats 6450 3D Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Coats 6450 3D