Coats 6450 3D Bedienungsanleitung PDF herunterladen (Seite 20)

14 • Important: Always read and follow the information box instructions.

Mounting Wheel on Spindle Shaft

CAUTION

Avoid back injury, seek assistance when

lifting heavy tire/rim assemblies onto the

balancer shaft.

CAUTION

Hubnut must engage threads for at least

four full turns. Failure to tighten hubnut

securely or to force wheel firmly against

the faceplate may result in serious personal

injury.

Select the most appropriate mounting method for

the wheel you are balancing. Using the proper method

ensures secure mounting and safe balancer operation,

and prevents damage to the wheel.

On most wheels, the inner side of the wheel hub usu-

ally has the most uniform surface for wheel balancing.

Always center the wheel by the most uniform shaped

side of the hub to achieve the most accurate balance.

Regardless of mounting type, always make sure that

the wheel is forced firmly against the shaft faceplate

and that the hub nut engages the threaded shaft for

at least four complete turns. To assist in centering the

wheel properly, rotate the wheel and the shaft while

tightening the hub nut.

Standard Back Cone Mounting

Use only small or medium cones.

1. Place spring over threaded stud with the large end

inside of the faceplate. Spring must be used.

2. Select a cone that best fits into wheel center hole.

Use only small or medium cones. If a larger cone is

required, use the front cone mounting system.

3. Slide selected cone onto threaded shaft with the

large end against the spring.

4. Lift wheel onto shaft and center on cone.

5. Slide pressure drum onto threaded shaft with the

large end against the spring.

6. Thread hubnut on and tighten with hubnut wrench.

If hubnut won’t tighten all the way down, use the front

cone mounting system. The wheel must be forced

firmly against the faceplate.

7. If you still can’t tighten hubnut because of a lack

of threads, use an additional cone to act as a spacer

between the hubnut and pressure drum.

Figure 17 - Back Cone Mounting

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Coats 6450 3D Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Coats 6450 3D