Coats 5035 A/E Tire Changer Bedienungsanleitung

Manual Part No.: 8183818Revision Date: 7/071601 J. P. Hennessy Drive, LaVergne, TN USA 37086 615/641-7533 800/688-6359HENNESSY INDUSTRIES INC.

2. Depress the inflation pedal to position 2 andhold about 1 second to begin air flow, thendepress pedal to position 3 and hold very briefly– less tha

Stand Back During Bead Seat and InflationPERFORMANCE, CUSTOM, ANDALUMINUM WHEELSOnly tire technicianswith experience andtraining on customwheels shoul

NOTE: Some wheels have a low pressuresensor/transmitter strapped to the wheel. This isespecially true on run-flat tire/wheel systems. Thesensor is pos

Figure 26 - Pull Lifting Tool Down and Rotate Wheel10. The lifting tool can usually be removed afterjogging the wheel a short distance. Continue tojog

Figure 32 - Use Hooked End of Bead Lifting Tool6. After beads are mounted, unclamp wheel, lift itslightly, and move the clamps to the center ofthe tab

5035 A/E Rim Clamp Tire Changer • 13Bead SealingA 140 PSI air blast from the table jets creates an aircurtain to aid in bead sealing. Never exceed 10

MAINTENANCE INSTRUCTIONSRead and follow all the maintenance instructionsprovided in this manual to keep the machine in goodoperating condition. Refer

Separator/Lubricator MaintenanceCheck oil and water levels regularly, and performthese maintenance items weekly:A. Disconnect air supply to machine.B.

– WARNING –– CRITICAL SAFETY INSTRUCTIONS –READ AND FOLLOWFAILURE TO FOLLOW ALL WARNINGS AND INSTRUCTIONS IN THISMANUAL MAY LEAD TO SERIOUS PERSONAL I

Table of ContentsDefinitions of Hazard Levels ...1Owner's Responsibility ...1P

Definitions of Hazard LevelsIdentify the hazard levels used in this manual withthe following definitions and signal words:DANGERWatch for this symbol:

Principal Operating PartsKnow Your UnitCompare this illustration with the unit before placingit into service. Maximum performance and safety willbe ob

OPERATING INSTRUCTIONSThe unit must be properly operated and properlymaintained to help avoid accidents that coulddamage the unit and injure the opera

5. Determine the mounting side of the wheel. Themounting side is the narrow side of the dropcenter. (Tire removed in Figure 4 for clarity.)Figure 4 -

Figure 9 - Insert Bead Lifting Tool11. Push the bead lifting tool down towards thewheel to lift the tire bead up and over the knobportion of the demou

MOUNTINGThis information must be read and followed carefullyto prevent accidents and injuries during mounting.Check tire and wheelcarefully beforemoun

INFLATIONTire inflation is performed in three steps: Bead Seal,Bead Seat, and Inflation. These steps are explainedin detail on page 13. Read the expla